HVAC & Plumbing Services in Mayfield Heights, OH

Replaced evaporator coil and outdoor condensing unit for complete air conditioning system installation. Performed deep vacuum test using digital micron gauge to verify system integrity and proper evacuation, achieving acceptable vacuum levels before refrigerant charge. Installed new air handler with clear access panel for future serviceability and completed all necessary refrigerant line connections to new outdoor unit.

Responded to service call for central air conditioning system not producing cold air. Upon inspection, found severely restricted airflow due to heavily clogged air filter at indoor air handler unit. Removed and replaced dirty pleated filter with new filter, restoring proper airflow to system. Verified Amana outdoor condenser unit operation, confirmed refrigerant pressures within normal range, and tested system performance. Unit now cooling properly with adequate airflow and temperature differential across evaporator coil.

Completed comprehensive preventative maintenance on an 11-year-old Carrier air conditioning system. Upon arrival, verified system was operating properly with no reported issues. Performed complete AC tune-up including inspection of outdoor condenser unit, electrical connections, and disconnect switch. Checked refrigerant levels, cleaned condenser coils, inspected condensate drain line, and verified proper airflow through the unit. Tested all electrical components including contactors, capacitors, and safety controls. Measured temperature differential and confirmed system performance within manufacturer specifications. All components found to be in good working condition with no immediate repairs required. System left operating efficiently and ready for continued cooling season use.

Diagnosed residential HVAC system and determined compressor failure requiring complete unit replacement. Provided customer with replacement estimate and scheduling options for new system installation.

Responded to no-cooling call on 20-year-old outdoor air conditioning unit where compressor failed to start despite condenser fan operating after capacitor replacement. Diagnosed failed compressor on aged system showing significant wear and corrosion on base pan and components. Documented unit condition with photos and provided recommendations for system replacement due to age and compressor failure.

Responded to a service call for a clogged kitchen sink and leaking main water line shut off valve. Upon inspection, found the main shut off valve assembly showing severe corrosion, mineral buildup, and active leaking at threaded connections. The valve body and lower pipe sections exhibited extensive rust deterioration and white chalky mineral deposits indicating long-term water exposure and age-related failure. Documented the condition of the deteriorated plumbing assembly with photographs showing the corroded galvanized and brass fittings, compromised threaded connections, and oxidized components throughout the vertical pipe assembly.

Completed preventive maintenance tune-up on a 10-year-old air conditioning system that was operating normally with no reported issues. Performed comprehensive system diagnostics using digital manifold gauges to verify refrigerant pressures and temperatures, inspected electrical connections and wiring within the service panel, and confirmed all components were functioning within manufacturer specifications. System left in proper working condition with all safety checks completed.

Responded to service call for older Crown boiler with active leak. Applied boiler sealer to address dripping issue as temporary measure. Assessed existing boiler system including copper piping network, expansion tank, and venting configuration. Provided replacement estimate options including standard boiler replacement and combination boiler upgrade alternatives for customer consideration.

Conducted on-site assessment for HVAC system replacement in residential basement installation. Evaluated existing furnace unit with heat exchanger and connected ductwork, documented current system configuration including flexible metallic ductwork routing and utility room layout with water heater proximity. Confirmed customer availability and provided comprehensive replacement estimate for new equipment installation.

Performed comprehensive air conditioning tune-up on a fifteen-year-old system that was operating without issues. Inspected and evaluated the air filter, which showed moderate dust and dirt accumulation throughout the pleated media, indicating normal use over its service period. Connected manifold gauge set to measure system pressures and verify refrigerant charge levels, confirming the unit was functioning within proper operating parameters.

Responded to service call for non-functional tanked water heater with reported gas leak and occasional "snowing" condition in 70-year-old residence. Upon arrival, inspected the white cylindrical water heater unit and surrounding plumbing connections, including copper piping, brass fittings, galvanized ductwork, and expansion tank assembly. Documented existing installation configuration showing multiple pipe connections at top of unit, adjacent blue water treatment system, and utility room conditions. Due to safety concerns regarding the reported gas leak, further diagnostics and corrective action were required to address both the operational failure and hazardous gas condition.

Performed comprehensive air conditioning tune-up on 15-year-old system including full inspection of blower assembly, which showed significant dust and debris accumulation on blower wheel fins and motor housing. Conducted combustion analysis and temperature differential measurements, recording supply air temperature of 330.5°F and achieving 15.7°F temperature split with CO2 levels at 0.66%, confirming proper system operation and efficiency within acceptable parameters.

Conducted on-site evaluation for complete HVAC system replacement. Assessed existing two-stage furnace unit in basement mechanical room, noting current configuration with PVC venting system and connection to existing ductwork. Inspected exterior utility connections and identified weathered condensate drainage lines showing significant deterioration and staining. Documented equipment specifications, spatial constraints, and existing infrastructure to provide comprehensive replacement estimate options. Coordinated arrival time and confirmed appointment for presenting three equipment replacement proposals to customer.

Completed spring air conditioning tune-up on one-year-old Bryant condenser unit. Performed comprehensive system inspection including refrigerant levels, electrical connections, capacitor testing, and airflow verification. Unit found to be operating within manufacturer specifications with no deficiencies noted.

Completed scheduled recurring cooling system maintenance on residential outdoor condensing unit located at rear of property. Performed comprehensive inspection of unit exterior, verified proper placement on pad with adequate clearance, confirmed electrical connections secure, and documented system condition with photographic records. Unit operational and functioning within normal parameters upon completion of service visit.

Responded to a request to disconnect and cap an existing dryer gas line due to safety concerns at a 73-year-old residential property. Upon arrival, found the gas line corroded onto the dryer connection, requiring careful disconnection to prevent damage to the existing gas piping system. Successfully disconnected the corroded gas line, installed appropriate gas line cap to ensure safe termination, and verified all connections were secure with no leaks detected. Gas shut-off valves were confirmed operational and left in the closed position for safety.

Performed comprehensive preventive maintenance on 7-year-old air conditioning system. Conducted system performance diagnostics using refrigerant manifold gauge, verifying R410A refrigerant pressures and temperatures within manufacturer specifications. Completed routine maintenance procedures including inspection of condenser unit, coil cleaning assessment, and overall system operational check to ensure optimal cooling performance for the season.

Completed maintenance plan renewal for residential HVAC system. During inspection, observed frost accumulation on evaporator coil and condensation on supply air grille, indicating potential airflow restriction or refrigerant issue that will require monitoring. Customer advised of maintenance plan options and coverage details.

Performed annual maintenance tune-up on 1-year-old Bryant air conditioning system. Upon arrival, noted that the decorative Bryant nameplate disc (5-6" diameter) from the top of the condensing unit had blown off due to wind. Conducted comprehensive system diagnostics using Fieldpiece SMAN refrigerant manifold and micron gauge, verifying refrigerant pressures, temperatures, and superheat/subcooling values to ensure proper system operation. All measured parameters were within manufacturer specifications. Completed standard maintenance procedures including inspection of electrical connections, capacitor testing, and airflow verification. System operating normally with no performance issues detected.

# AC Maintenance Completed Performed comprehensive air conditioning maintenance on outdoor condensing unit. Connected digital manifold gauge set with refrigerant hoses to service ports to measure system pressures and temperatures. Utilized Fieldpiece SMAN diagnostic equipment to evaluate refrigerant charge levels, superheat, and subcooling values. Readings indicated system operating parameters were within acceptable range at 212.1°F discharge temperature with corresponding pressure readings of 313 PSIG. Conducted electrical testing with digital multimeter to verify proper voltage and amperage to compressor and condenser fan motor. All electrical components tested within manufacturer specifications. Inspected condenser coil fins for debris and damage, confirmed adequate airflow through unit. Verified fan motor operation and blade condition. System operating efficiently with no refrigerant leaks detected and proper cooling capacity restored.