HVAC & Plumbing Services in Shaker Heights

Successfully installed new digital water feeder on steam boiler, including complete wiring integration into the existing system. Verified proper operation of the electronic control board and confirmed absence of water leaks upon completion of installation.

Performed annual furnace tune-up which included inspection of heat exchanger coils that showed significant dust/dirt accumulation requiring cleaning. Combustion analysis performed with digital analyzer confirming proper operation with readings of 21.0% O2, 0 PPM CO, 0.00% CO2, and stack temperature of 107.7°F.

Performed scheduled boiler maintenance including inspection of heat exchanger coils which showed normal dust accumulation but no significant deterioration. Replaced corroded anchor bolts in two rows (4 upper, 5 lower) that were showing substantial rust and wear.

Performed scheduled Home Plan Heating Tune Up on dual furnace system. Inspected and cleaned blower wheel assemblies on both units, documenting condition with photos. Both furnaces functioning properly after maintenance service completed.

Completed annual inspection on residential steam boiler system. Examined burner assembly with blue flame operation, checked all copper piping connections, and ensured proper pressure readings. Customer renewed maintenance plan with payment collected onsite.

Performed routine tune-up on 7-year-old furnace and inspected exterior AC unit for potential damage caused by fallen gutter as requested. Examination of system components revealed normal wear on the blower wheel assembly and slight condensation on ductwork seams, which were properly sealed with HVAC tape. No significant damage was found on the outdoor condenser unit.

Performed scheduled maintenance on two furnace systems. Inspected electrical components and control boards, confirming proper operation of all indicator lights and connections. Systems tested with all safety controls functioning normally and units operating at optimal efficiency.

Performed scheduled boiler tune-up service, inspecting heat exchanger components which showed signs of oxidation and dust accumulation on the metal fins. Observed multiple rows of heat transfer elements with some corrosion present but still functional. Service was rescheduled from a previous appointment.

Performed annual boiler tune-up service. Inspected sight glass assembly for proper operation and fluid levels. Examined ductwork connections and verified integrity of wall-mounted control unit. System is functioning normally with no issues identified.

Performed standard maintenance on 13-year-old MVP gas furnace. Inspected gas valve assembly, verified proper flame characteristics with healthy blue flames indicating good combustion, and ensured all wiring connections were secure and properly functioning. System is operating normally with no issues detected.

Performed second opinion inspection of HVAC system to address temperature inconsistency concerns between floors. Evaluated ductwork configuration and airflow distribution from single air handler serving multiple levels. Documented existing installation including ceiling registers and previous modifications where steam boiler coil was removed.

Addressed severe corrosion and leakage at hydronic radiator pipe union in basement. Replaced deteriorated pipe section and fitting that showed significant rust formation and water damage to surrounding joists. Pressure tested system after repair to verify integrity of copper distribution lines and ensure proper operation of heating system.

Successfully installed a new Bryan 50-gallon, 40k BTU tall water heater with recirculation system, properly connected using PEX B piping. Completed all necessary connections in the basement mechanical room, ensuring proper function of the water heating system while addressing previous water leakage issues evident on the concrete floor.

Identified and replaced leaking radiator valve on a 10-year old steam boiler system. Performed comprehensive system check and confirmed proper operation after repair. All connections were tested for leaks and system was returned to normal operation.

Completed annual inspection of 3-year-old boiler system under Natural Home Plan. Inspected expansion tank, copper piping network, valves, and fittings throughout the basement utility area. Verified proper operation of heating components and documented condition with photos of the main boiler unit and associated mechanical equipment.

Performed scheduled Home Plan Cooling Tune Up on furnace system. Inspected gas valve functionality and verified proper burner operation with clean blue flame pattern. Temperature measurements confirmed system operating within normal parameters at 21.0°F differential. All components functioning correctly with no issues detected.

Successfully removed and replaced faulty air tube in mechanical system. Performed complete operational cycling test to verify proper function. Total service time: 1.5 hours.

Responded to service call for reported water leakage from radiator system. Upon inspection, identified significant corrosion at pipe connections of cast iron radiator located in dining room. Observed water damage to wooden flooring surrounding radiator pipe penetration and confirmed related ceiling collapse in basement storage area directly below. Documented condition with photographs showing deteriorated fittings and water staining.

Responded to no-heat call for recently installed steam boiler (less than 2 months old), finding system completely inoperative with black condensate discharge throughout. Discovered missing main vent pipe (MVP) causing improper system operation; installed proper venting and cleaned affected areas. System now operating correctly with proper flame pattern and combustion observed.

Responded to service call for non-operational mini split system. Performed diagnostic inspection of indoor air handler located in attic space, which was properly insulated with reflective material. Examined exterior condenser unit and verified all line connections were secure. System is now functioning within normal parameters.