South Euclid HVAC Services

Responded to service call regarding kitchen sink leaking at drain connection. Upon inspection, identified water leakage from the P-trap assembly beneath the sink. Replaced faulty P-trap components and verified proper drainage with no leaks after repair.

Performed comprehensive furnace tune-up and diagnostic testing, with combustion analysis showing normal O2 levels at 11.4%, minimal CO presence, and CO2 at 5.4% with system temperature at 94.1°F. Inspected humidifier and verified customer has appropriate filters on hand.

Performed scheduled maintenance tune-up on 3-year-old furnace. Inspected interior components including fan assembly and air handler, confirming all parts are clean, intact and functioning properly. System is operating within normal parameters with no issues detected.

Responded to main water line leak emergency requiring city water shut-off. Installed new copper pipe fittings at the source of the leak, replacing damaged section with proper elbow joint and securing to framing with pipe support brackets. Confirmed repair was successful with no moisture ingress after service completion.

Performed estimate for furnace and air conditioner replacement of aging equipment. Inspected existing HVAC system, including copper line sets, ductwork, and electrical connections. Evaluated electrical panel capacity to ensure compatibility with potential new system requirements.

Performed inspection on 13-year-old York furnace after buyer's inspection noted gas odor near regulator in upper cabinet. Located and repaired significant corrosion and rust at gas line connection point. System now operating safely with no gas leaks detected.

Performed routine maintenance on Heatmaker furnace system located in basement utility area. Conducted comprehensive inspection of belt-driven unit, checking flame pattern and internal components for proper operation. System is functioning correctly with no immediate issues identified; customer advised about maintenance plan renewal options.

Diagnosed and repaired leaking Bradford White tanked water heater in 50-year-old residential property. Identified leak source at bottom connection point, replaced deteriorated fittings and installed new expansion tank to prevent future pressure issues. Confirmed proper venting of exhaust system and verified all connections were secure with no further leakage detected during testing.

Performed furnace tune-up maintenance service. Inspected flame pattern through sight glass, confirming proper combustion with characteristic blue flame. System is operating normally with no issues detected.

Diagnosed non-operational humidifier system and identified severely clogged evaporator coil as primary cause of poor indoor air quality and system inefficiency. Performed thorough cleaning of evaporator coil to remove extensive dirt buildup and debris accumulation, restoring proper airflow and humidity control capabilities. Recommended regular maintenance schedule to prevent future IAQ issues and extend equipment lifespan.

Performed routine furnace tune-up, inspecting gas burner assembly which showed proper blue flame ignition and combustion. Examined heat exchanger, blower motor, and electrical connections which were all functioning within specifications. System is operating efficiently with no issues detected.

Performed inspection on recently installed Bryant condenser unit damaged by falling ice from roof. Documentation of visible damage to exterior cabinet, fan assembly, and refrigerant lines was completed with photographic evidence. Recommended full replacement of condenser under warranty due to extensive impact damage affecting operational integrity of the system.

Performed preventative maintenance on 12-year-old gas furnace. Completed deliming and descaling service on tankless water heater system. Inspected plumbing connections and drainage system components, noting proper installation of flexible braided supply lines and pump assembly.

Performed scheduled maintenance on Rheem water heater system, including a complete tankless flush to remove mineral buildup. Inspected all copper pipes, valves, and connections for proper function and signs of wear. Replaced air filter to maintain optimal system performance and efficiency.

Performed 12-point tune-up on 21-year-old furnace. Inspected burner assembly and verified proper flame pattern with strong blue flames indicating good combustion. Combustion analysis readings showed normal operation with O2 at 7.0%, CO at 17 PPM, CO2 at 7.9%, and stack temperature at 407.2°F, confirming efficient operation within manufacturer specifications.

Inspected heating system and identified severe corrosion and rust damage on the heat exchanger fins. The metal components show extensive deterioration with rust stains spreading to surrounding surfaces. Recommend immediate replacement of the heat exchanger due to safety concerns and potential efficiency loss.

Successfully installed new Bryant furnace and digital programmable thermostat as part of a dual fuel hybrid system. Reconnected to existing 2" PVC venting and preserved the customer's current air cleaner, humidifier, and Carrier heat pump. System is functioning properly with temperature reading 72°F and humidity at 33%.

Performed exterior faucet repair on a 90-year-old home. Inspected the connection point where plumbing meets the brick foundation and vinyl siding. Service completed during winter conditions with snow present around the work area.

Responded to service call for furnace operation concerns following a reported pipe burst incident. Upon inspection, verified furnace is operational with normal gas ignition and flame sequence. Visual examination of heat exchanger and control components revealed no damage or abnormalities. System is functioning properly with no compromised components detected.

Performed inspection of aged gas water heater (10+ years) that has never been flushed. Unit is installed on concrete floor with tile sections underneath, connected to copper and PVC plumbing with proper metallic vent pipe. Provided customer with replacement options and recommendations based on current condition and age of equipment.