HVAC & Plumbing Services in Shaker Heights

Completed preventative maintenance on two air conditioning systems. Performed standard cooling season inspection including checking refrigerant levels, testing electrical connections, cleaning condensate drains, inspecting blower wheel assembly for debris accumulation, and verifying proper airflow and system operation on both units.

Completed heating tune-ups on multiple heat pump systems in a residential property with radiant heating distribution and boiler components. Performed comprehensive maintenance inspections, verified proper operation of all heating equipment including the Quantum boiler unit, checked PVC exhaust venting systems, and confirmed all manifold connections and pressure readings were within normal parameters.

Performed scheduled maintenance on Bradford White water heater in basement utility room. Inspected unit operation, tested temperature and pressure relief valve, checked all copper piping connections and shut-off valves, and verified proper functioning of expansion tank. Documented equipment condition with photos showing all mechanical connections, ductwork, and plumbing infrastructure in satisfactory working order.

# HVAC Maintenance - Cooling System Service Performed comprehensive preventative maintenance and tune-up on a Carrier air conditioning unit less than 10 years old located in exterior side yard area. Utilized Fieldpiece SMAN refrigerant manifold and micron gauge to verify system pressures and temperatures, recording readings of 99.6 psig on low side and 194.4 psig on high side with corresponding temperature measurements. Inspected condenser coil fins, refrigerant lines, and electrical connections at outdoor unit. All system parameters tested within normal operating range and unit found to be functioning properly upon completion of seasonal maintenance service.

# HVAC Service - Boiler Responded to service call for boiler leaking hot water from bottom, upper left-hand corner. Upon arrival, parked in back of driveway per customer request and proceeded to inspect the unit. Investigation revealed active water leakage originating from the lower section of the boiler assembly. Documented conditions with photographs showing water accumulation on basement floor with visible staining and moisture damage to surrounding concrete surfaces. The leak source was traced to the upper left-hand corner area of the boiler's lower section, indicating potential failure of internal components, gaskets, or tank integrity. Photographed evidence of water intrusion and assessed the extent of damage to the installation area. Customer was advised of findings and provided recommendations for repair or replacement options based on the age and condition of the unit.

Completed comprehensive air conditioning tune-up on residential split system with outdoor condensing unit and indoor air handler. Performed full system inspection including visual assessment of both indoor and outdoor components, verified proper operation of condenser fan and compressor, checked refrigerant lines and electrical connections, and confirmed adequate airflow through evaporator coil. System found to be operating within normal parameters with no immediate service needs identified.

Performed complete air conditioning tune-up on outdoor condensing unit. Conducted comprehensive system inspection including temperature and pressure diagnostics, cleaned condenser coils, verified proper refrigerant levels, and tested electrical components to ensure optimal cooling performance for the upcoming season.

Completed scheduled preventive maintenance on 5-year-old Carrier air conditioning system. Performed comprehensive AC tune-up including inspection of outdoor condensing unit, compressor assembly, and electrical disconnect. Verified all refrigerant lines, conduit connections, and mounting hardware secure and properly installed. System operating within normal parameters with no deficiencies noted.

Completed annual AC tune-up on three-year-old residential air conditioning system. Performed comprehensive inspection of outdoor condensing unit, verified proper operation of all components, and confirmed system is functioning within normal parameters. Unit shows no signs of immediate service needs and is operating efficiently.

Performed comprehensive estimate for HVAC system replacement on residential property with 1990s-era furnace that remains operational. Evaluated existing indoor furnace unit located in basement and outdoor condensing units positioned at building exterior, documented current equipment condition and configuration, and provided homeowner with replacement options for aging but functional heating and cooling system.

Replaced existing residential water heater with new white cylindrical unit in basement mechanical room. Installation included connecting copper supply and distribution lines to overhead plumbing system, ensuring proper venting, and verifying all safety labels and temperature-pressure relief valve are in place and functional.

Completed comprehensive air conditioning tune-up on residential cooling system. Performed standard preventive maintenance procedures including inspection of evaporator coil assembly, which showed normal operational wear with good structural integrity. System tested and confirmed operating within normal parameters with no deficiencies noted requiring immediate attention.

Completed comprehensive AC tune-up and maintenance on Lennox cooling system in basement mechanical room. Performed standard preventive maintenance procedures including system inspection, filter check, and operational testing to ensure optimal performance for the cooling season. System found to be in satisfactory working condition with all components functioning properly.

Responded to service call for shower lacking hot water in 90-year-old home. Diagnosed and replaced faulty Kohler shower valve cartridge and trim components, restoring proper hot water function to shower fixture. Performed routine inspection of sump pump system with no issues found. Completed annual backflow prevention assembly test on sprinkler system per code requirements, with device testing within acceptable parameters.

Responded to service call for leaking tanked water heater in basement utility room. Upon inspection, identified active leak condition on water heater unit with white cylindrical tank configuration. Assessed plumbing connections, copper supply lines, and surrounding area for moisture damage and safety concerns. Photographed equipment and installation for documentation purposes, noting concrete floor staining consistent with water leakage.

Responded to dispatch for non-operational attic HVAC unit. Upon inspection, assessed existing system located in attic space with flexible ductwork connected to aging equipment. Documented current installation including exterior HVAC unit and building infrastructure. Provided comprehensive estimate for complete system replacement to restore climate control functionality.

Performed comprehensive maintenance on 13-year-old Dunkirk DBU-125/DSL-125 hot water boiler system in conjunction with air handler service. Conducted thorough inspection of all boiler components, verified proper operation of electrical controls and safety systems including high-limit switches and flame sensors, checked burner assembly and combustion chamber for efficiency and safety compliance. Inspected and tested circulator pump motor with LED status indicator confirming proper operation, examined all gas and water line connections for leaks, verified proper venting and condensate drainage. Confirmed all manufacturer specifications are being met for gas supply pressure and water column relief settings. System operating within normal parameters with all safety certifications current and equipment functioning as designed.

Conducted on-site evaluation of 13-year-old residential HVAC system for replacement estimate. Assessed outdoor condensing unit showing significant age-related deterioration, including rust streaking, corrosion around mounting hardware, and weathered housing. Noted unit installed on ground with leaf debris and vegetation growth rather than proper concrete pad. Inspected indoor equipment including furnace and air handler in basement location. Documented existing system configuration with connected ductwork and control components. Photographed equipment condition and installation details to support replacement recommendation.

Responded to emergency water leak in basement of 96-year-old residential property where hot water tank was actively flooding the area. Upon arrival, assessed the compromised water heater and associated plumbing connections, including overhead piping infrastructure with PVC and gas lines running through exposed floor joists. Addressed the Lochinvar brand water heater failure, secured the water supply, and mitigated the active flooding condition to prevent further property damage to the basement structure and stored contents.

Responded to service call for hot water leaking from bottom of tanked water heater. Upon arrival, inspected Rheem brand water heater unit located in basement utility room. Observed visible water staining and discoloration on concrete floor surrounding base of tank, confirming active leak from lower section of vessel. Determined tank integrity had been compromised, likely due to internal corrosion and sediment buildup consistent with age of home and equipment. Documented condition of unit with photographs showing manufacturer labels, plumbing connections, and evidence of water damage at floor level. Advised that bottom tank leaks indicate failure of steel liner and are not repairable, requiring full water heater replacement to resolve issue and restore hot water service.